The Versatile Substance That Is Carbon Black
I suspect very few of us think much about carbon black.
In an over fifty-year working life, I have only come across carbon black indirectly and no-one has actually shown me any carbon black.
This is the first sentence of the Wikipedia entry for carbon black.
Carbon black (with subtypes acetylene black, channel black, furnace black, lamp black and thermal black) is a material produced by the incomplete combustion of coal tar, vegetable matter, or petroleum products, including fuel oil, fluid catalytic cracking tar, and ethylene cracking in a limited supply of air.
It doesn’t sound the most appetising of substances and the next sentence reinforces that view.
Carbon black is a form of paracrystalline carbon that has a high surface-area-to-volume ratio, albeit lower than that of activated carbon. It is dissimilar to soot in its much higher surface-area-to-volume ratio and significantly lower (negligible and non-bioavailable) polycyclic aromatic hydrocarbon (PAH) content.
The text is illustrated with what looks like a small pile of soot.
I first came across carbon black, in my first job after leaving Liverpool University at ICI Mond Division at Runcorn.
For a time, I shared an office with Peter, who was part of a number of engineers, who were trying to get a new plant, that had been purchased from BASF to make commercial quantities of acetylene. All the plant seemed to make was large quantities of soot, which it then proceeded to spread all over the town of Runcorn.
If I remember correctly, the process worked by burning ethylene in a limited supply of air and then quenching it with naphtha. The similarities between the BASF process and the method for producing carbon black lead me to believe, that ICI’s process was probably producing a lot of carbon black.
Peter was working on an instrument that measured the quantity of acetylene in the off-gas from the burners and he succeeded, but unfortunately proved that the plant was going into explosive limits. For this reason, ICI shut their process, although BASF persevered.
Ethylene is a hydrocarbon which has the formula C2H4 or two carbon and four hydrogen atoms. So if you can get them to stop tightly holding hands with no oxygen around, the hydrogen will pair off as H2 and the carbon will exist as a lot of single C atoms or carbon black.
BASF and ICI were trying to produce acetylene or C2H2, where there is a powerful triple bond between the two carbon atoms. All that energy in the acetylene makes it useful for activities like welding.
Common Uses Of Carbon Black
The Wikipedia entry for carbon black, has this summary of its uses.
The most common use (70%) of carbon black is as a pigment and reinforcing phase in automobile tires. Carbon black also helps conduct heat away from the tread and belt area of the tire, reducing thermal damage and increasing tire life. Its low cost makes it a common addition to cathodes and anodes and is considered a safe replacement to lithium metal in lithium-ion batteries. About 20% of world production goes into belts, hoses, and other non-tire rubber goods. The remaining 10% use of carbon black comes from pigment in inks, coatings, and plastics, as well as being used as a conductive additive in lithium-ion batteries.
The entry then gives a list of other uses, some of which are still being developed.
Global Production Of Carbon Black
This paragraph is from the Wikipedia entry for carbon black.
Total production was around 8,100,000 metric tons (8,900,000 short tons) in 2006. Global consumption of carbon black, estimated at 13.2 million metric tons, valued at US$13.7 billion, in 2015, is expected to reach 13.9 million metric tons, valued at US$14.4 billion in 2016.
So we have the useful paradox, that we don’t want to emit more carbon dioxide, but extra carbon black could probably be usefully used.
Conclusion
Using the HiiROC process to extract hydrogen could even give us a biproduct ; carbon black, that has uses.
Regulator Approves New Go-op Train Service Between Swindon, Taunton and Weston-super-Mare
The title of this post, is the same as that of this press release from the Office of Rail and Road.
This is the sub-heading.
The rail regulator has given the go ahead for new train services between Swindon, Taunton and Weston-super-Mare from the end of 2025. The regulator has also set conditions on its approval to ensure the new, co-operatively owned operator has sufficient finance and rolling stock in place in good time.
These paragraphs from the press release give more details.
Go-op plans to operate return weekday and weekend services between Taunton and Weston-super-Mare, Taunton and Westbury, Taunton and Swindon, and Frome and Westbury.
It will compete with Great Western Railway (GWR), a public service operator. Go-op plans to start in December 2025 at the earliest, and must do so no later than December 2026 in order to use the capacity ORR has granted.
As part of ORR’s decision, Go-op must provide evidence to ORR of the necessary finance to start operations, fund level crossing enhancements, and that the necessary rolling stock has been secured. ORR’s decision requires Go-op to do this without delay, and no later than November 2025.
I must admit I’m a little surprised at the Office of Rail and Road giving approval.
There is more on the Go-op web site.
London’s New Tram-Like Buses Come Into Service
The title of this post, is the same as that of this article on the BBC.
I went to Orpington station and all I saw was several small diesel single-decker buses running around in the awful cold.
So I retreated on a warm train after a couple of hours.
One driver said that the reams were running and she looked genuinely disappointed, that they hadn’t turned up.
But from my knowledge of electric vehicles, although not Irizar ie Trams, I do wonder if the single-figure temperatures in Orpington had drained the batteries.
But I can’t imagine a company like Irizar making a mistake like that.
Although one of the station men said that Orpington can get to be a very cold station. Now that is something I’ll agree with!
In the other hand the 358 route takes an hour from end to end, so in my opinion, it might have been better to use hydrogen-powered buses.
The Anonymous Widower 